Road Service:
If your equipment is broke down or maybe just in need of planned maintenance (PM), you can call on us. We have 4 fully stocked and well equiped service vans ready to make repairs at your location. Each van stocks the most popluar parts needed to get your equipment up and running, while minimaizing downtime. Our road technicians are highly trained and have decades of experience. Mobile tire pressing coming soon. Please contact Larry Crye to schedule your PM or road repair.
| Shop Service:
If your repair is too large or may need special equipment to complete, you can call on us! Our shop is fully equiped to repair many types equipment. We have a large steam cleaning area, in-ground forklift hoist, and overhead cranes to tackle the most time consuming and dedious types of repairs. Our shop technicians are also highly trained and well equiped to handle any repair you may need. We press tires at our facility. Please contact Larry Crye to schedule your shop service today.
|
|
WHAT DOES OUR FORKLIFT PM SERVICE ENCOMPASS???
|
|
INTERNAL COMBUSTION ENGINES:
-
new air filter
- new oil filter
- fresh engine oil
- top off and check all fluids (antifreeze, hydraulic, transmission, brake, and battery)
- lubricate all zerk fittings
- clean and coat battery cable ends/posts and check for corrosion
- inspect distributor cap, rotor, ignition system, and plug wires
- check for any leaks (engine oil, hydraulic fluid, L.P. gas, etc.)
- inspect safety equipment (brake lights, horn, strobe light, etc.)
- inspect and lubricate (if needed) chains, mast slide rails, and sideshift rail
- blow out radiator and engine compartment
- check: forks and latches, load backrest, and over head guard
- inspect brake pedal free play, stopping response, inching control, and park brake
- check all tire wear, lugs and lug nuts
- AND EVEN MORE!!!
ELECTRIC UNITS:
-
many of the above items PLUS...
-
check speed control, creep speed, 1A speed
-
inspect drive motor, hydraulic motor, and power steering motor
-
inspect and blow out all motor brushes and contactor tips
-
check battery discharge indicator
-
check seat switch and brake switch for proper operation.
|
|
WHAT DOES OUR OTHER PM SERVICES ENTAIL???
|
|
BATTERY PM SERVICE:
- check each cells voltage and specific gravity
- check battery connectors
- clean, inspect, and coat posts and cable ends
- check cables for wear and tear
- inspect battery seal for leaks
- check and top off water levels
- clean any corrosion
CHARGER PM SERVICE:
DOCK PM SERVICE:
-
inspect springs, welds, and latches
-
lubricate all movable joints
-
check chains and connections
-
inspect for leaks
-
insure proper operation
-
clean out pit
|
|
|
